Surface Mounting; Ventilation - bora PIW 1 Instrucciones De Montaje Y De Uso

Installation

Surface mounting

The distance between the cut-out edge and the
rear and side walls must be minimum 65 mm.
For practical reasons, we recommend a distance of
at least 115 mm between the outmost section edge
and the sidewall.
■
For installation in built-in kitchen units, ensure
that the plastic or veneer of the units is applied
with heat-resistant
otherwise become
especially at the edges.
■
Seal the exposed cut-out edge with a sealant
such as silicone.
■ Please observe the manufacturer's instructions
of your worktop regarding its suitability.
26
adhesive as it might
loose or deformed,
Cut-out dimensions
for the installation of
cooktops or for
cooktops and BORA
cooktop extractor fans
beside each other:
Between all build-in appliances, spacing of
1 mm is intended.
Install the installation rail supplied with your
appliance between the BORA built-in appliances or
the appliance and the BORA cooktop extractor fan.
Please observe the installation instructions
on page 27!

Ventilation

■ The front cross-strip of
the cabinet is to be
removed so that a
ventilation opening is
created beneath the
worktop over the whole
width of the appliance.
■ Any
cabinet cross-
strips that there might be in the area of the
worktop cutout are to be removed.
g
Worktop
cut-out
B
1 346
2 717
3 1088
1 1 457
2 1 828
3 2 1310
4 2 1681