Cooktop Installation - bora PIW 1 Instrucciones De Montaje Y De Uso

Installation
► Mount the toggles. Ensure that dimension
18,5 mm is maintained when the knobs are in
0 position.
Cover
Toggle
► If the two toggles are not at the
same distance from the power
control sleeves,
distance with the adjusting screw
in the toggle shaft, using the
enclosed Allen wrench.
toggles must be at a distance of
18,5 mm from the
sleeve (see above diagram).
Power control
sleeve
Allen
wrench
adjust the
Both
respective

Cooktop installation

■ The use of solid timber wall strips behind the
built-in cooktop on the worktop is permissible,
provided the required minimum distances are
maintained.
■ The use of plastic wall strips is not permissible.
■ Changes in the surface colour normally result
from the effect of light.
► Prior to inserting the cooktops, please insert the
cover frame of the cooktop extractor hood (1) in
the worktop cut-out.
► To balance out the higher glass thickness of the
induction glass ceramic wok and the tolerances,
please use the provided height adjustment
plates (2).
► Afterwards the appliance can be inserted (3).
Please check that all build-in appliances are
flush and adjust height using the height
adjustment plates if necessary.
g
29