Corghi Erco X5000 CT LT PT2 FAST Manual De Uso página 70

WARNING
Do not remove or modify any part of this machine.
CAUTION
Keep the working area clean.
Never use compressed air, water jets or aggressive chemical substances to remove
dirt or traces from the machine.
When cleaning, try as far as possible to avoid generating or raising dust.
Maintenance by unauthorised staff is strictly forbidden.
To ensure the machine remains in good working order and operates correctly, it is essen-
tial to follow the instructions given below, carrying out cleaning and routine maintenance
every 1000 working hours.
Routine cleaning and maintenance operations must be carried out in accordance with
the instructions given below:
- Cleaning and maintenance operations must be carried out in conditions of maximum
safety, setting the lift in a mechanically safe position.
- Turn the master switch to zero '0' and disconnect the machine's electrical contacts.
- Change the hydraulic fluid in the control unit tank (capacity 15 l) about every 1,000
working hours, using the fluids recommended in the table below:
SUPPLIERS NAMES
API
MOBILOIL
SHELL
ESSO
BP
AGIP
FINA
- Clean the lift, taking special care over any outside objects which might cause malfunc-
tions of the mechanical and electrical safety devices.
70
HYDRAULIC CONTROLS
CIS 32
DTE24
TELLUS 25
NUTO HP 32
ENERGOL HLP65
OSO 35
HYDRAN 31
GREASE LUBRICATION
PIGREASE LT-S
MOBILPLEX 46
ALVANIA EP 1
BEACON EP 1
ENERGREASE LS 1 EP
GR.MU EP 1
MARSON EPL 1
Operator's manual ERCO X5000 CT LT PT2 FAST