Warranty Statement - Worx WG206 Manual Original De Instrucciones

where it may be cut by the blade.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade.
Allow the cutting blades to reach full speed
before entering the material to be cut.
Always work going away from people and
solid objects such as walls, large stones, trees,
vehicles etc.
If the blade stalls, immediately stop the Hedge
trimmer. Disconnect the Hedge trimmer from
the power supply and clear the jammed debris
from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Move the Hedge trimmer to feed the branches
directly into the blade cutting edges.
Do not try to cut stems that are too large to
feed into the cutting blade.
TOP cUTTING (see e)
Use a wide sweeping motion. A slight
downward tilt of the cutting blades in the
direction of motion gives the best cutting
results.
sIde cUTTING (see f)
When trimming the sides of the hedge, begin
at the bottom and cut upwards, tapering
the hedge inward at the top. This shape will
expose more of the hedge, resulting in a more
uniform growth.
WaRNING: Check extension cords
before each use. If damaged replace
immediately. Never use your tool with a
damaged cord since touching the damaged
area could cause electrical shock resulting in
serious injury.
If the supply cord is damaged, it should be
replaced by a local approved Service Center.
Take care not to expose this tool to rain.
MAInTenAnCe
cLeaNING
Disconnect from power supply. Using a soft
brush-remove debris from all air intakes and
cutting blade.
Wipe over surface of your Hedge trimmer with
a dry cloth.
Hedge Trimmer
WaRNING! Never use water for
cleaning your Hedge trimmer. Do
not clean with chemicals, including gas, or
solvents as this can damage your hedge
trimmer.
LUbRIcaTING THe cUTTING bLade
For easier operation and longer life, lubricate
the cutting blades before and after each use.
Before lubricating, make sure your Hedge
trimmer is disconnected from the power
supply. Apply a light household oil so that it
runs between the two blades.
Your trimmer should be stopped, disconnected
and oiled occasionally during use.
aT THe eNd Of THe cUTTING seasON
Clean your Hedge trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the Hedge trimmer for any
worn or damaged parts.
TO sTORe YOUR HedGe TRIMMeR
Store the hedge trimmer in a secure, dry place
out of the reach of children. Do not place other
objects on top of the machine.

WARRAnTY STATeMenT

30 DAY Satisfaction Guarantee
If for any reason you are dissatisfied with any
WORX product, you can return the product,
along with proof of purchase, within 30 days
for a full refund.
If your WORX product becomes defective due
to faulty materials or workmanship within the
specified warranty period of;
• 24 months for DIY and light trade use, from
the date of purchase.
We guarantee to repair or replace all defective
parts free of charge, repair products subject
to fair wear and tear, free of charge, or at our
discretion, replace the unit free of charge
to ensure minimum inconvenience to the
customer. Your warranty is subject to the
following conditions:
• Proof of purchase date and a valid receipt is
produced.
•The product has not been misused.
09 09
en