Instructions For Putting Into Operation; General; Mobile Headlight Aiming Devices; Hlt 600 And 610 - Nussbaum HLT 600 Instrucciones De Manejo

ENGLISH

Instructions for putting into operation

Instructions for putting into operation
Instructions for putting into operation Instructions for putting into operation Instructions for putting into operation
Before the headlight aiming device is put into initial operation the
alignment mirror and the handle on HLT 600 and 610 must be
turned to the working position.
Operations required to do this
G
Release the locking screw (1) on the equipment support
column using a 4 mm hexagon-socket screw key.
G
Swing the arm holding the alignment mirror 180° upward (2).
G
Tighten the locking screw again.
Fig. 1
Operations required to do this
G
Release the locking screw (1) on the equipment support
column using a 5 mm hexagon-socket screw key.
G
Swing the handle 90° outwards.
G
Insert the locking screw in the hole and tighten.
Fig. 1a
1 689 979 219N
1. 1. 1. 1. 1.

General

General
General General General
Headlamps on motor vehicles must not blind the drivers of vehicles
coming from the opposite direction. The inclination and the aiming
of the headlamp light beam to the side must therefore be adjusted
according to legal specifications.
In order to make these legally specified adjustments of motor-
vehicle headlamps, Nussbaum supplies the following aiming de-
vices:
1.1

Mobile headlight aiming devices

HLT 600 and 610

! The surface on which the headlight aiming device is
set up must be even but it does not have to be
horizontal.
In order to achieve the specified measurement accu-
racy, surface irregularities within the area where the
aiming device is used must be less than 1.2 mm.
Fig. 2
1 alignment mirror
2 handle
3 luxmeter
4 deflection mirror
5 markings for lens center
11