Installing The Unit In The Sunroof - Dometic COOLAIR RT780 Instrucciones De Montaje

CoolAir RT780, SP950T
7.6

Installing the unit in the sunroof

➤ Set the unit down centrally aligned and in the direction of travel (fig. 0) on
the sunroof opening.
I
NOTE
Make sure the air conditioning roof unit is centred perfectly. The seal must be
applied continuously around the air conditioning roof unit after being placed
on the roof of the vehicle. This is the only way to ensure a tight seal.
➤ Position the fastening holder under the cab roof (fig. a). The fastening
holder is pushed between the cab roof (chassis) and the roof lining.
A
NOTICE!
The fastening holders must be positioned on a firm surface, since the unit will
be pushed against the cab roof by the holder. The contact surface of the fasten-
ing holder must be at least 40 mm on all sides.
A
NOTICE!
Do not exceed the specified torque under any circumstances. This is the only
way to ensure that the thread inserts are not torn out.
➤ Fix the parking cooler in place as illustrated (fig. a)
➤ Determine the length of the hex screw M8 required for securing the
installation as shown in fig. c:
Screw length = distance between the bottom edge of the fastening bar and
the bottom of the unit plus 5 mm). If necessary, shorten the hex screw to the
size determined.
EN
Installation
13