SKF TKRS 41 Instrucciones De Uso página 14

No. Position of the
selector switch (E)
3. MENU
Phase shift (PHASE in deg)
Phase shift setting (in degrees, relative to the frequency) between the trigger signal and lash. This value allows a ixed
angle to be set between the trigger signal and lash.
•
Example without external connection: The viewing position can be extremely precisely adjusted without
changing the lash frequency. You can shift the viewing position within a movement cycle.
•
Example with external connection: The external trigger signal is triggered before the desired observation point
(= lash position of the stroboscope). This would mean that the connected stroboscope would regularly lash too
early. The PHASE deg setting adjusts the delay, altering the lash position of the stroboscope by a set angle.
This setting is not affected by the current rotational speed, which means that the stroboscope will lash at the
desired position even during rotational speed luctuations or during the start-up period.
How to select in the MENU:
1 Turn the selector switch (E) to the "MENU" position.
2. Select which parameter (e.g. PHASE deg) you want to change using the rotary/push knob (D).
3. Push the rotary/push knob (D) to conirm a parameter selection.
→ The following will appear in the display:
→ the number display will lash
4 Select the desired value using the rotary/push knob (D).
5. Conirm and exit selection by pushing the rotary/push knob (D).
þ
This setting is now active.
12 EN
Display Adjustable Description
parameters
PHASE deg.: Delay setting between the trigger
signal and lash (in degrees,
0 ... 359
relative to the frequency).
Position ixed; actual delay
depending on current frequency.