Cleaning The Sealing Plate; Danger Of Burns; Disinfecting The Machine - Orved N Serie Manual De Uso

9.3.4. CLEANING THE SEALING PLATE

DANGER OF BURNS!

Wear heat-resistant safety gloves and clothing!
keep alcohol-based detergents and other inflammable products far away from the machine.
For cleaning the sealing plate correctly and removing encrustation, if any, AVOID USING ABRASIVE SPONGES,
SHARP TOOLS OR EQUIPMENT as this can damage the Teflon coating on the plate, making the film stick to the
plate during the sealing phase.
1) Switch the machine on.
2) Adjust plate temperature between 70 and 80°C (Fig. 1).
3) Wear heat-resistant safety gloves and clothing to proceed with cleaning the plate using an abrasive sponge dipped
in cold potable water. Let the water evaporate. Repeat the operations until the plate is totally free of all residua and
encrustation.
4) When cleaning is complete, before switching off the machine, remember to adjust again to the sealing temperature
set earlier.
If cleaning is not satisfactory, causing defective film sealing, contact an authorized service centre.

9.3.5 DISINFECTING THE MACHINE

Switch the machine off via the ON/OFF main switch and disconnect the plug from the mains.
• Spray the steel surfaces of the machine with an alcohol-based disinfectant. Do not spray the product on electric parts
or in the ventilation slots of the machine.
• Let the disinfectant sit for a few minutes.
• Wipe with a cloth soaked in drinking water and then dry well with a clean cloth.
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N
CONTROL, CLEANING, SANITIZATION OF MACHINE
Fig. 1
41