SKF TMRT 1 Instrucciones De Uso página 7

11. Display orientation - Inverting function - All modes
11.1. The instrument can be used through 180° rotation (e.g. with the light
beam pointing downward into a machine), the display inverts so that
normal reading can take place.
11.2. The UP Button selects normal mode for optical and contact
measurements.
11.3. The Down button selects the display inversion mode and the whole
display including relevant icons will reverse through 180 degrees
allowing access to difficult applications.
12. Remote Input_(TMRT 1 only)
12.1 The TMRT 1 can be connected to a remote laser sensor, designation
TMRT 1-56. Plug the remote input into the jack socket located at the
rear end of the instrument. The TMRT 1 will now operate as normal
but the sensing will be via the remote laser.
12.2 The remote sensor may be hand held or mounted on a bracket,
designation TMRT 1-60, enabling permanent mounting.
Note. The internal optical system is automatically disabled in this mode.
13. Battery replacement
Power requirements: 4 x AAA alkaline cells
Warning for TMRT 1Ex:
Battery Replacement
Batteries must only be replaced with Duracell "Procell" AAA cells. The
battery compartment lid must only be opened in a safe area.
To open the lid, first unscrew the security screw with the special tool provided
until it moves freely. The screw is a captive type and should not be removed
from the lid. Once the screw moves freely, press the thumb grip on the lid and
push/slide the lid backwards and lift off. The old batteries can then be replaced
ensuring correct orientation. Replaced the lid ensuring the security screw is
pulled upwards to avoid catching underneath. The base of the lid is now pushed
until a click is heard, tighten the security screw and the unit is ready for use.
14. Maintenance
Important: Repair or servicing should only be carried out by SKF.
Warning for TMRT 1Ex
1. The TMRT 1Ex is not intended to be exposed to dusty conditions.
2. If excessive wear/corrosion has taken place to the plating on the housing and
another colour begins to show through, the unit must be returned to SKF for
attention.
3. The TMRT 1Ex should not be subjected to mechanical or thermal stress, nor
should it be subjected to any aggressive substances.
Note
This instrument has been designed such that it will not give rise to injury or other
harm due to contact, nor will it produce excessive heat, infrared,
electromagnetic or ionising radiation, nor does it have any non-electrical
dangers.
15. Spare parts and accessories
Designation
TMRT 1-56
TMRT 1-57
TMRT 1-57K
TMRT 1-59
TMRT 1-60
Description
Laser remote sensor (for TMRT 1 only)
Contact adapter
Tyre and RPM cone set
Reflective tape
Bracket for laser remote sensor
7