Blackmagic Design MultiView Serie Manual De Instalación Y Funcionamiento página 122

This example is for the Blackmagic MultiView 16 which has 16 sources and 18 views including
solo which is view 16 and audio which is view 17, referred to here as outputs.
Legend
↵
line feed
...
and so on
Version 2.3 of the Blackmagic Videohub Ethernet Protocol
was released with Videohub 4.9.1 software
Initial Status Dump
The next two blocks enumerate the labels assigned to the input and output ports.
INPUT LABELS:↵
0 VTR 1↵
1 VTR 2↵
...
↵
OUTPUT LABELS:↵
0 Output feed 1↵
1 Output feed 2↵
...
↵
Note: Input and Output labels are always numbered starting at zero in the protocol which
matches port one on the chassis.
The next three blocks describe the routing of the view ports.
VIDEO OUTPUT ROUTING:↵
0 5↵
1 3↵
...
↵
The next block describes the locking status of the views. Each port has a lock status of "O" for
ports that are owned by the current client (i.e., locked from the same IP address), "L" for ports
that are locked from a different client, or "U" for unlocked.
VIDEO OUTPUT LOCKS:↵
0 U↵
1 U↵
...
↵
The last block is the configuration block.
Layout: SOLO or 2x2 or 3x3 or 4x4
Output format: 50i or 50p or 60i or 60p
Solo enabled: True or False
Widescreen SD enable: True or False
Display border: True or False
Display labels: True or False
Display audio meters: True or False
Display SDI tally: True or False
Information pour les développeurs 122