Blackmagic Design MultiView Serie Manual De Instalación Y Funcionamiento página 83

Pin No.
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pinout diagram for the RJ11 connector
Notifications
Once connected, if status reporting is enabled, the client will receive a notification message
when a route changes on the MultiView. The notifications take one of two forms:
S:0destination,source
This message indicates that the specified source port is now routed to the specified
destination.
V:0destination,source
This message indicates that the current preset includes a route from the specified source to the
specified destination.
Global Commands
All pass through commands are preceded by an
The following client commands are supported:
disable status reporting
@ !
Status reporting is disabled by default.
enable status reporting
@ ?
Status reporting is enabled.
reset routing table
@ Z:
Routing is reset so that the first source is routed to all destinations.
Immediate Commands
@ X:0/destination,source
@ X:0/destination,source/destination-2,source-2
The specified source ports are routed to the specified destinations.
Any routing changes will trigger
request individual route status
@ X?0destination
The source routed to the specified destination will be returned as an
request all ports route status
@ S?0
Each source and destination port pair will be returned as
Function
TX +
TX -
GND
GND
RX -
RX +
Routing change
Preset routing notification
symbol and a space.
@
change route
notifications
S:
... change multiple routes
S:
notifications
S:
Developer Information
notification.
83