Descargar Imprimir esta página

Teranex Mini Smart Panel; Installing Teranex Mini Smart Panel - Blackmagic Design MultiView Serie Manual De Instalación Y Funcionamiento

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 175
Use the rotary knob or the view buttons on
Blackmagic MultiView 16's control panel to
assign values to your network settings
Teranex Mini Smart Panel
The Teranex Mini Smart Panel mounts to the front of your Blackmagic MultiView 4 and replaces
the original basic panel. You get fast access to your settings using buttons, a rotary knob and
built in LCD.

Installing Teranex Mini Smart Panel

Installing your optional Smart Panel is easy and because the panels are hot swappable you
don't even need to turn off your Blackmagic MultiView 4 when installing it.
1
Remove the two M3 screws on each side of your Blackmagic MultiView 4's basic front
panel using a Pozidriv 2 screwdriver and gently pull the panel away from the front
of the unit.
2
On the inside of the basic panel, you'll notice a small clear plastic tube attached to
the bottom corner. This tube directs light from the LED inside the unit to illuminate
the status indicator on the basic panel. This tube should stay attached to the basic
front panel.
TIP
If reattaching the basic front panel, make sure the light pipe for the power
indicator is aligned with the slot in the front of the unit.
3
Align the connector on the rear of the Smart Panel with the adjoining connector on the
face of your Blackmagic MultiView 4 and gently push the Smart Panel towards the unit
until the connectors are firmly seated. The Smart Panel should make a firm connection
and fit neatly inside the face of your Blackmagic MultiView 4.
4
Re-insert the M3 screws from the original panel.
If your Blackmagic MultiView 4 is installed in a Teranex Mini Rack Shelf, you will need to remove
the unit from the rack shelf to access the front panel screws.
See the 'Rack Installation' section for more information.
Your Blackmagic MultiView 4's USB port is still accessible with the Smart Panel attached.
To access the port, simply open the rubber USB dust cover. With the Smart Panel installed, the
front panel small switches are covered up and no longer used. This is because all settings can
now be changed via the LCD menus.
Teranex Mini Smart Panel
15

Publicidad

loading