Hilti SF 4-A22 Manual Del Usuario página 17

5.4 Fitting the belt hook (optional)
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself
and others.
▶ Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by
the operator. The belt hook can be fitted to allow attachment on the left
or right side of the body.
1. Remove the battery. → page 10
2. Insert the belt hook into the opening provided at the base of the product.
3. Secure the belt hook with the two screws.
4. Insert the battery. → page 10
5.5 Installing Hilti bit holder (optional)
1. Remove the battery. → page 10
2. Insert the bit holder into either the left or right opening provided at the
base of the product.
3. Secure the bit holder with the two screws.
4. Insert the battery. → page 10
5.6 Hilti Installing the retaining strap (optional)
ATTENTION
Damage to the product and / or the lanyard. Incorrect handling can result
in damage to the product and/or lanyard.
▶ Do not use a metal chain as a lanyard. Do not use lanyards longer than
2,0 m (6 ft).
To avoid damage and injury, when working at a height it is advisable to
use the Hilti retaining strap.
The retaining strap allows a securing cord or lanyard to be attached.
When working with the product, you must comply with national regula-
tions for working at heights.
1. Remove the battery. → page 10
2. Insert the two tabs on the retaining strap into the slots on each side of the
base.
3. Secure the retaining strap with the screws supplied.
4. Insert the battery. → page 10
*2253605*
2
2253605
3
4
English 11