again. Do not use the heater in case of damage or malfunctioning. Have the appliance
inspected/repaired!
In case of internal overheating, the overheating safeguard will switch the heater off. This
may occur if the heater cannot give off enough heat or if it cannot draw in enough fresh air.
As mentioned above, this is generally caused by (partially) covering the heater, obstructing
the air intake and/or outlet grills or installing the heater too close to a wall or something
similar. In case of overheating, switch off the heater and unplug. Give the heater time to cool
down, remove the source of the overheating and use as normal. If the problem persists or if
you have not been able to trace the source of the overheating, turn the heater off immediately
and unplug. Contact a servicing point to have the heater repaired.
Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of
overheating so these should be removed regularly. Switch off the heater, remove the plug
from the socket and allow the heater to cool down before cleaning or carrying out
maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical solutions!
Use a vacuum cleaner to carefully remove any dust and dirt from the grills and ensure
that the air intake and outlet openings are clean. Be careful not to touch or damage any
internal parts during cleaning!
The heater contains no other parts which need maintenance.
At the end of the season, store the cleaned heater in the original packaging if possible.
Store it upright in a cool, dry and dust-free place.
Do not dispose of heater with household waste when it becomes worn or damaged
beyond repair. Take it to your local authority's collection point for electrical appliances
where any reusable materials will be collected and redistributed.
CE-statement
Eurom - Genemuiden-NL hereby declares that the EUROM electrical convector heater,
type CK2003T, complies with the LVD guideline 2014/35/EU and the EMC guideline
2014/30/EU and meets the following standards:
EN 60335-1:2012+A11 :2014
EN 60335-2-30:2009+A11 :2012
EN 62233:2008
RoHS 2011/65/EU
Genemuiden, 29-04-2016
W.J. Bakker, alg. dir.
EN 55014-1 :2006+A1 :2009+A2 :2011
EN 55014-2 :1997+A1 :2001+A2 :2008
EN 61000-3-2 :2014
EN 61000-3-3:2013
18