Zanussi ZBT27430SA Manual De Instrucciones página 11

Ventilation requirements
The airflow behind the
appliance must be
sufficient.
x
If necessary cut the
adhesive sealing strip
and then apply it to the
appliance as shown in
figure.
www.zanussi.com
5 cm
min. 200cm
x
Install the appliance in
the niche.
Push the appliance in
the direction of the ar-
rows (1) until the up-
per gap cover stops
against the kitchen fur-
niture.
Push the appliance in
the direction of the ar-
rows (2) against the
cupboard on the op-
posite side of the
hinge.
Installing the appliance
Caution! Make sure that the mains cable
can move freely.
2
Do the following steps:
min.
200cm
2
2
4mm
1
44mm
Adjust the appliance in
the niche.
Make sure that the dis-
tance between the ap-
pliance and the cup-
board front-edge is 44
mm.
The lower hinge cover
(in the accessories
bag) makes sure that
the distance between
the appliance and the
kitchen furniture is cor-
rect.
Make sure that the
clearance between the
appliance and the
cupboard is 4 mm.
Open the door. Put
the lower hinge cover
in position.
I
I
Attach the appliance
to the niche with 4
screws.
11