Connection With The Mains; Operation; Stand Alone Operation; Dmx-Controlled Operation - Futurelight PHS-1200E Pro-Head-Spot Manual Del Usuario

Only use a stereo shielded cable and 3-pin or 5-pin XLR-plugs and connectors in order to connect the
controller with the device or one device with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last device, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into an XLR-plug and plug it in the DMX-output of the last device.

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

After you connected the effect to the mains, the PHS-1200E starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the PHS-1200E can be used without controller.
Disconnect the PHS-1200E from the controller and call the internal program.
Please refer to the instructions under Control Board, Functions, menu Auto program.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
International
L
N
48/130
resistor
00026924.DOC; Version 1.6