Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION
1- Monitor
2- Handrail
3- Motor cover
4- Main unit
5- Rear roller
6- Wheels
ASSEMBLY INSTRUCTIONS
Take the unit out of the box and place it on the
floor as shown in figure 0.
We recommend another person's help for
assembly.
Check to see that it has all its parts: (B) Main
structure; (A) Set of fastening devices: (a) Bolt
M8x15 4 units, (b) lock pins, (c) washers 4 units, (i)
Allen keys, (k) Safety key, (l) Bottle of lubricant.
Follow each of the steps in the assembly
instructions
1. RAILING ASSEMBLY.-
We recommend another person's help for
this assembly step
Join the handrail (2) to the base (4) using the
bolts and washers, securing each side as
shown in Fig. 1.
2. FITTING THE MONITOR.
Connect the monitor (1) to the handrail (2) using
the bolts and washers, as shown in Fig. 2.
3. FOLDING UP YOUR UNIT
To fold your unit, stop the machine completely
and unplug it from the wall socket.
Lift the base of the machine, as shown in Fig. 3,
and secure it with the lock pin (b). You can now
release the machine.
4. UNFOLDING YOUR UNIT
To unfold the machine, follow the opposite steps
to those done when folding it: Hold the machine
with one hand and use the other to pullo ut the
lock pin (b) and slowly lower the machine down to
the ground, as shown in Fig. 4, When folding or
unfolding the treadmill make sure that there are
no hildren about or obstacles that might hinder
the folding motion.
MOVEMENT & STORAGE
equipped with wheels (6) to make it easier to
move. Make sure that the mains cable is
unplugged from the wall socket.
To prevent accidents DO NOT move the
treadmill across uneven floors.
MAINTENANCE
Use the bottle of lubricant (I) to lubricate the
inside of the belt in order to keep your unit in top
condition and to ensure that friction between the
belt and the board is kept to a minimum Fig. (5)
(due to different running styles, always apply
more lubrication to the area where you place
your feet during the exercise) It is advisable to
lubricate the base of the belt every 3 -12 months,
depending on how often it is used. If the belt
starts to slip after lubrication, then check the
tension of the belt. To tension the belt, take the
6 mm Allen key (i) and with the machine set to
4 km/h turn screws (R & L) one turn in a
clockwise direction.
Operating speed
1~6 km
6~12 km
12~16 km
DO
NOT
LUBRICANTS
ADJUSTING THE BELT
If your unit is not seated evenly on the four
contact points, this may cause the belt (X) to shift
sideways. Rigorous quality control adjusts and
checks the running belt. However, due to weight
differences and individual styles of running, the
belt may be prone to shift sideways.
If the belt does shift to the left or right, stop the
machine.
15
Recommended lubrication
period
1 year
6 months
3 months
USE
SOLVENT
The unit is
BASED
Publicidad
Tabla de contenido
