Identification And After-Sales Service; After-Sales Service; Spare Parts; Identification And Servicing - Grillo G Z2 Manual De Instrucciones

24) Before starting any work with the machine, check that all the accident prevention systems whit
which it is equipped with are in perfect working order. They must never be disabled or tampered
with.
25) Before starting work, check that the nuts and bolts securing both rotary tiller and tines are
perfectly secured.
26) Never operate the machine without safety procedure devices in place (e.g. mudguards and
engine bonnets).
27) Never clean the tiller with the engine running.
28) Never use the machine barefoot.
29) Never change the maximum RPM engine settings nor any other engine setting.
30) Allow the engine to cool before storing in any enclosure.
31) CAUTION: to reduce the risk of fire, keep the engine, the exhaust pipe and the exhaust
manifolds free from grass, leaves, dust, etc...
32) Drain the fuel only outdoors.
33) Tiller must be driven by one operator only.

IDENTIFICATION AND AFTER-SALES SERVICE

AFTER-SALES SERVICE

This manual provides instructions for the use of the tiller and for its correct basic servicing which
the user can carry out themselves. For all procedures not described in this manual, contact your
local dealer.

SPARE PARTS

Always use original spare parts, as they are the only ones to offer complete safety and
interchangeability. Always state the serial number of the machine and the code number or the part
to be replaced when ordering. For engine parts, refer to the specific handbook.
GUARANTEE
The guarantee is given in compliance with the current law. The dealer will have to give the client a
copy of the registration card of the machine, which they will print up from the Grillo website.
engine the guarantee of the relative manufacturers apply.
ORDERING SPARE PARTS
Always state the machine serial number and the code number of the part to be replaced. Contact
your local dealer. For further information, our address is:
GRILLO S.p.A.
Via Cervese 1701 - 47521 CESENA (FC) - ITALY
Tel. 0039 / 0547 / 633111 - Fax 0039 / 0547 / 632011
Web site: www.grillospa.it - E-mail:
RECOMMENDED SPARE PARTS TO HAVE AT DISPOSAL
1 throttle lever
1 tiller engagement cable
1 reverse gear belt
G Z2-G Z3/ Translation of the original instructions
grillo@grillospa.it
5
The tiller is fitted with a nameplate on the
frame with the serial number of the machine.
Always state the serial number when
ordering spare parts or asking for technical
support.
For the