Ega Master 79921 Manual De Instrucciones página 26

• Observe local safety regulations.
• Avoid use of force when disassembling and assembling the machine.
NOTICE
After completing maintenance and repair work and before restarting production make sure that...
• All materials, tools and other equipment which are required for maintenance or repairs have been removed from
the work area of the machine.
• Any fluid leaks have been removed.
• All safety devices on the machine have proper function.
• The oil level was checked.
• Fixtures of screw connections are checked.
• Removed container covers, screens or filters were reinstalled.
Inspection and maintenance can be done by the operator, disassembly and reassembly of the machine have to be
executed by qualified staff only. Incorrect assembly can lead to danger of accident for the operator and to defects on the
machine.
Generally, hydraulic machines need little maintenance. If the following rules are observed, the machine will have the
expected long life-time and high reliability:
Regular check of exterior damages on the machine.
Regular check of the hydraulic filter/ the hydraulic fluid.
In case of disturbances we recommend sending the machine to the manufacturer.
Disconnect the machine from hydraulic supply prior to disassembly!
Only skilled staff are allowed to execute disassembly and assembly. Check the adherence to the technical
specifications after each maintenance work. Only use genuine spare parts. Otherwise you risk a decrease in performance
and an increase in maintenance work.
There is no warranty for damages and liability is disclaimed, if non-original spare parts are used.
The operator makes sure that all maintenance, inspection and assembly work is done by authorized and qualified
personnel, who is appropriately informed by thorough study of the operation manual.
NOTICE - Check fixtures of screw connections after work is executed
If necessary: Re-tighten fixing screws
The manufacturer service is available for all maintenance, repair and assembly work.
We assume no liability for improper use or operation!
Maintenance of hydraulic tools
Only proper maintenance can ensure constant performance, reduction in wear and thus, a decrease in operating costs
and an increase in service life.
Our hydraulic tools are equipped for an operating pressure of up to 100 bar. Regulator setting for a lower operating
pressure is possible.
The tools should not run empty, because this results in heat and higher wear of the output section and the tool
holder.
The hydraulic oil should be clean. This is ensured by professional equipment.
Clean the connecting parts before connecting the hydraulic hoses.
For an economic use of the hydraulic tools the required sizes of pipe, fittings and hoses have to be adjusted.
Proper greasing of the gear and the tool heads is a must. See the operation manual on this.
26
INFORMATION SHEET