dirna Bergstrom bycool SLIM FIT Instrucciones De Montaje página 19

SLIM FIT
OUTSIDE CABIN:
5
Position Slim Fit in sun hatch hole.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
Types of hatch:
!
- Hatch A: Here M8 studs can be threaded
without removing the inner air distribution
panel.
- Hatch B: Here M8 studs cannot be threaded
without removing the inner air distribution
panel.
HATCH TYPE A:
7a
CABIN INTERIOR:
Screw (4) 8/125x100-70 or 120 studs around
5 mm; the size will be chosen after positioning
the fastening mounts and bearing in mind that
the studs must protrude from the bottom by
about 20 mm.
Air conditioning for vehicles
Sun hatch
Unit base
7a
19
5 mm
Stud
Bracket
20 mm
EN
5
7a