Topcom 2000 Manual De Usuario página 7

The Setup Wizard will show the cameras that are connected to your network.
The default IP address of the IP CAM is 192.168.1.90.
• If your network is in a different subnet, it is recommended to run the Wizard first.
• If your network is in the same subnet as the IP CAM, you can access the IP CAM's web
interface by clicking the Link button.
In this case it is not necessary to click the Wizard button!
To run the "Wizard", click the
If the IP CAM is not in the same Subnet as your local network, next message will appear:
– Click "Yes" to continue
Wireless IP Cam 2000 / Wired IP Cam 1000
Wireless IP Cam 2000 / Wired IP Cam 1000
button.
7