GUTMANN NIVEL 8000 ML Instrucciones De Montaje página 40

Ocultar thumbs Ver también para NIVEL 8000 ML:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 98
EN
7. MOUNTING REQUIREMENTS -
Installation, important notes!
• Avoid excessive heat generation from
below, e.g. from a baking oven wit-
hout cross-flow fan.
• The induction hob must not be used
when pyrolysis operation takes place
on built-in cookers.
• When installing above a drawer, care
must be taken to ensure that no
sharp objects are stored in the dra-
wer. These could tilt on the underside
of the hob and block the drawer.
Ensure that the cooktop inductors are
adequately ventilated.
• The cooktop must not be installed
above
refrigerators,
washing machines or dryers.
• It must be ensured that no flammable,
easily ignitable or heat deformable
objects are placed directly next to or
below the hob due to the risk of fire.
Hob gasket
Wood worktops must be sealed on the
cut surfaces.
Before installation, the enclosed cooktop
gasket must be inserted without gaps.
• It must be prevented that liquids can
penetrate between the edge of the
40
PREPARATIONS
• If the hob is installed in an uneven
Note:
• If sealing adhesive is used for sealing
Worktop cut-out
dishwashers,
The cut-out in the worktop should be
made as accurately as possible with a
good, straight saw blade or a router
The cut surfaces should then be sealed
to prevent moisture from penetrating.
The cut-out for the hob is made accord-
ing to the illustrations. The glass-
ceramic hob surface must be flat and
flush. Tensioning can cause the glass
plate to break. Check the seal of the
cooking surface for a perfect fit and
complete support.
Floor and plinth cut-out
Depending on the base height, the cut-
out in the base plate can vary.
It is recommended to discharge the ex-
haust air through openings in the plinth
front strip.
KITCHEN FURNITURE AND WORKTOP
hob and the worktop or between the
worktop and the wall into any electri-
cal appliances installed underneath.
worktop, e.g. with a ceramic or similar
covering (tiles, etc.), the sealing must
be carried out with level compensati-
on of the cooking surface against the
worktop using plastic sealing materi-
als (e.g. Novasil® or Ottoseal® ).
and fixing, a later, non-destructive
removal of the hob cannot be guaran-
teed.

Publicidad

Tabla de contenido
loading

Tabla de contenido