Display Elements - Bosch GAM 220 MF Instrucciones De Funcionamiento Y Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The numbering of the product features shown refers to
the illustration of the anglefinder on the graphic page.
1 Fold-out leg
2 Viewing window for dis-
3 Locking knob
4 Base leg
5 Battery lid
6 Latch of battery lid
7 Display
8 Spirit level for horizon-
9 Spirit level for vertical
The numbering of the product features shown refers to
the illustration of the anglefinder on the graphic page.
a "H" indicator for "HOLD" memory value
b Battery indicator
c Reading
d Bevel angle indicator "BVL"
e Miter angle indicator "MTR"
f
g Spring angle indicator "SPR"
Use alkaline (4 x AA) batteries to operate the anglefinder.
correct battery polarity may cause fire or personal injury.
To open the battery lid 5, press on the latch 6 and fold the
battery lid up. Insert the batteries (Fig. A).
Battery Indicator
The battery indicator b always displays the current bat-
tery status:
Always replace all batteries at the same time. Do not use
different brands or types of batteries together.
Remove the batteries from the digital level when not
using it for longer periods. When storing for longer peri-
ods, the batteries can corrode and self-discharge.
Slide the leg extension 17 onto the fold-out leg 1 from the
front. Slide the leg extension as far as possible over the
joint of the anglefinder.
2610035049 GAM220MF 05-19.indd 7
play
tal alignment
alignment

Display elements

Corner angle indicator "CNR"
Inserting/Replacing the Batteries
The battery is over 90 % full
The battery is between 60 % and 90 % full
The battery is between 30 % and 60 % full
The battery is between 10 % and 30 % full
The empty battery indicator flashes. The battery
level is under 10 %. Once the battery indicator be-
gins flashing, you can measure for approximately
another 15-20 minutes until the tool shuts down.
Mounting the Leg Extension
Features
10 Serial number
11 "HOLD" button
12 "ON/OFF" button
13 Button for rotating the
display
14 "MTR1" button for sim-
ple miter
15 "MTR2"
compound miter
16 Protective pouch
17 Leg extension
Assembly
Ensure polarity of each battery
matches the instructions in Fig. A. In-
button
for
7
5/22/19 10:08 AM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3 601 k76 610

Tabla de contenido