Operation
Playing a CDG (Continued)
888
U
V
ak
888
6
Adjust the volume to a comfortable
level using the MASTER VOLUME
control.
7
Connect microphone(s) and slide the
ON/OFF switch on the microphone to
the ON position.
8
Rotate the MIC VOLUME control
as desired. Increasing this control
will increase the volume of both
microphones.
9
Rotate the ECHO control to add an
echo effect to your voice. Rotate
towards MAX to increase the echo
effect
10
AUTO VOICE CONTROL can be
activated by pressing the AVC
button. The vocals on the multiplex
recording will be muted when the
singer starts to sing through the
microphone. When the singer stops
at
singing, the recorded vocals on the
multiplex recording will resume to
X
normal.
W
11
Rotate the BALANCE control
clockwise to hear the music and
recorded vocals from a multiplex
recording or counterclockwise to
hear the music only from a multiplex
recording.
Note: To use the BALANCE control, a CD+G
disc must be used, otherwise it will operate as
a standard Balance control.
8
Operation
Playing a CDG (Continued)
888
888
12
Adjust the Key to obtain the best key
for the singer on the track. Adjust
the key using the KEY – and KEY +
buttons.
13
al
SKIP: Advance or go back one track
by pressing the Skip Back 9/Skip
am
Forward : buttons.
14
REPEAT: During playback, press the
REPEAT button once to repeatedly
play the selected song
display. Press the REPEAT button a
second time to repeatedly play the
whole CD
A
will display. Press it
again to cancel Repeat function
will display.
15
PROGRAM: You can program up to
20 tracks on any disc for playback
in any desired order. While in the
Stop mode, press the PROGRAM
button; the Program indicator first
track using the Skip Back 9/ Skip
Forward : buttons. Press the
ao
PROGRAM button again to confirm
the entry. After selecting the desired
tracks the display will show P01, P02,
an
etc. recognizing the tracks selected
have been programmed.
Repeat to set up to 20 tracks into
memory. When done, press the Play/
Pause button to start playback.
Note:
• Press the Stop < button TWICE to stop
and clear the program.
9
1
will