Berner 052872 Instrucciones De Manejo página 6

INSTRUCTION MANUAL
Read and understand these instructions before operating the tool.
:
Modell BPT-COG
Air supply requirements
Supply tool with 6.0 bar of clean, dry air. Higher pressure drastically reduces tool life
and/or can cause several injury.
Connect tool to air line using pipe, hose and fitting sizes shown in the diagram above.
Do not install a quick coupler directly into the air tool throttle handle.
In order to have the tool working to full satisfaction the minimum air delivery must be at
least 10% higher than the indicated air consumption of the air tool.
Please consult the technical data in this instruction manual.
Instruction of use
Please make sure that if the tool is fitted with a torque/air regulator, that the torque
achieved complies with the application.
If an extra support handle is supplied with the tool that it be fitted before the tool is used
and hold, if possible, the tool with two hands.
Lubrication
Use an air line lubricator with oil, adjusted to two (2) drops per minute.
If an air line lubricator cannot be used, then once a day add 1 or 2 drips special (SAE 10).
Air motor oil into the air inlet.
052872 Corner grinder