Getting Started; Insert Batteries - Explore Scientific WSH4002 Manual De Instrucciones

GETTING STARTED

INSERT BATTERIES

1. Remove the battery door from the back.
2. Insert 2x AA (LR6)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon in-
stallation.
3. Reattach the battery door.
NOTE: Replace batteries when [
when the display is dim.
OUTDOOR SENSOR
The main unit can receive data from up to 3 outdoor
sensors. 1 Sensor is included with delivery.
1. Remove the battery door from the back.
2. Select a channel, then press TX.
3. Insert 2x AAA (LR03)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon in-
stallation.
4. Reattach the battery door.
5. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
8
TO SEARCH FOR A SENSOR:
The main unit will automatically search for a new sen-
sor after the batteries are installed. To manually initi-
ate a outdoor sensor search, press and hold [
NOTE: The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.
] displays, or
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC recep-
tion is initiated. To manually start RCC reception
press the [
2. The receiving process duration is 7 minutes.
3. During receiving process, the RCC signal symbol
shows:
4. If the RCC receiving process is successful, a com-
pleted RCC symbol [
and the date and time will be set automatically. If it
fails within 7 minutes, RCC setting will quit automati-
cally. If that happens, press and hold the [
ton to re-initiate RCC receiving.
] button.
.
[ ]
] will be shown in the display
].
] but-