Getting Started - Explore Scientific WSH0002 Manual De Instrucciones

GETTING STARTED

INSERT BATTERIES
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please
ensure the polarities (+/-) of the batteries
match upon installation.
3. Reattach the battery door.
OUTDOOR SENSOR
The main unit can receive data from up to 3
outdoor sensors. 1 Sensor is included.
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please
ensure the polarities (+/-) of the batteries
match upon installation.
3. Select a channel, then press TX.
4. Reattach the battery door.
5. Place the sensor within 30 m (98 ft) of
the main unit using the table stand or wall
mount.
NOTE: Replace batteries when [
or when the display is dim.
CLOCK
SET THE CLOCK MANUALLY
1. Press and hold [
into time and date setting.
2. The setting parameter will flash.
3. Press [ ] button once, the figure will
increase 1 unit. Press and hold the [
button, the figures will increase rapidly.
4. Press [ ] button once, the figure will
decrease 1 unit. Press and hold the [
button, the figures will decrease rapidly.
5. Press [ ] button to confirm setting
and enter to next parameter.
6. Sequence of setting: Zone 12H/24H 
Year (2000 - 2009)  Month  Date 
Hour  Minute  °C/°F  Exit
7. If there is no action in 20 seconds, the setting
will be saved and will exit the setting mode.
] displays,
] button to enter
]
]
7
EN
IT
DE
FR
ES