2. Slide the telescopic tubes onto the hose handle, see Figure 3A.
3. Press the button on the telescopic tubes and keep it pressed in; you can then extend or retract the
tubes to the required length. See Figure 3B.
Figure 4 Soft and hard surfaces
4. Press the foot button on the nozzle to set the combi nozzle for use on hard or soft surfaces, see Figure
4. For use on hard surfaces, press the foot button on the combi nozzle to extend the brushes. Lift the
button for use on soft surfaces.
Figure 5 Markings on the power cord
5. The power cord has a yellow and red mark, see Figure 5. Pull out the cord to the yellow mark.
Never pull out the power cord beyond the red mark. This could damage the power cord.
6. Put the plug in the wall socket, and press the On/Off switch. To switch off the appliance, press the On/
Off switch again, see Figure 6.
Figure 6 On/Off switch
7. The appliance is now ready for use. You can move the vacuum cleaner while you are cleaning by
pulling on the hose grip. You can lift the appliance with the vacuum cleaner's handle.
Figure 7 Vacuum suction control
8. You can adjust the vacuum suction with the vacuum suction control, see Figure 7. It is advisable to
reduce the vacuum suction when cleaning upholstered furniture and curtains. This will prevent the
fabric from being sucked into the nozzle.
note
If so required, you can also reduce the suction quickly by moving the slide on the hose grip.
26
user's instructions