Automatic Power-Off; Setting The Date/Time - WIKA GFU08 Manual De Instrucciones

7. Display unit
7.6

Automatic power-off

The "Automatic power-off" function is activated/deactivated via SETUP.
If the weighing platform is unladen, if the load is not moved or if, in the set time period
(1 to 255 minutes), no button is pressed, the display will show a blinking "-oFF-". After
EN
an audible signal, the display unit will automatically switch off.
7.7 Automatic stand-by function
The "Auto stand-by" function is activated/deactivated via SETUP.
The display unit is generally in stand-by mode (the display is switched off, except for the
decimal point). On pressing any button, the message "- on -" will be shown briefly. The
weight on the scales will be displayed for 30 seconds. After this time, the display unit will
return to the stand-by mode.
7.8

Setting the date/time

The display unit can be fitted with the date/time option or it could already be fitted. As
soon as the display unit is (for the first time) switched on, the display shows "CloCK".The
setting of date and time is made in the SETUP area.
7.9 Print
If a printer is connected, there is the possibility to print the programmed weight data,
such as:
4 headers, each of 24 characters
■
Gross weight
■
Net weight
■
Number of print document
■
Hour and date (optional or as standard, depending on model)
■
Barcode from model 39
■
It is also possible to send the weight data to a PC via the printer port. This is achieved
via standard or extended string (parameter "ALL.Std/ALL.EHt o PrPC.St/PrPC.EH in
Pr.NodE").
The print is confirmed by the display of the "PRinT" message in the display, or the
■
message "-tot-" in the case of totalising.
If the printing is no longer activated, the display shows the message "no.0 . un.5"
■
For unstable weights, the display shows the message "unStAb".
■
If the gross or net weight is smaller than the required minimum load, after pressing
■
the ENTER/PRINT button, the display shows the error message "LoW".
If the display unit has an under or overload, after pressing the ENTER/PRINT button,
■
the display shows the error message "un.oVEr"
30
.
WIKA operating instructions SF gas filling cart, model GFU08
6
.