Bluetooth - Kenwood KDC-BT268U Manual De Instrucciones

BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Connect the microphone
Rear panel
Microphone input jack
( 29)
Pair and connect a Bluetooth device for the first time
1
Press to turn on the unit.
2 Search and select this unit model name (KDC-BT2*) on the Bluetooth device.
"PAIRING" "PASS XXXXXX" Device name "PRESS" "VOLUME KNOB" appears
on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification
Number (PIN) code immediately after searching.
3
Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
12 ENGLISH
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Microphone
(supplied)
Secure using cord clamps
(not supplied) if necessary.
Once pairing is completed, Bluetooth connection is
established automatically. "BT1" and/or "BT2" on the
display window lights up.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will
remain registered in the unit even if you reset the unit.
To delete the paired device,
• A maximum of two Bluetooth phones and one Bluetooth
audio device can be connected at any time.
However, while in BT AUDIO source, you can connect to
five Bluetooth audio devices and switch between these
five devices. ( 17)
• Some Bluetooth devices may not automatically connect
to the unit after pairing. Connect the device to the unit
manually.
Adjust the
• Refer to the instruction manual of the Bluetooth device
microphone angle
for more information.
Auto Pairing
When you connect iPhone/iPod touch/Android device to
the USB input terminal, pairing request (via Bluetooth) is
automatically activated.
Press the volume knob to pair once you have confirmed
the device name.
Automatic pairing request is activated only if:
– Bluetooth function of the connected device is turned on.
– [AUTO PAIRING] is set to [ON]. ( 16)
– KENWOOD MUSIC PLAY application is installed on the
Android device ( 7) and [BROWSE MODE] is selected ( 8).
16, [DEVICE DELETE].