STARTING THE DIFFUSER
Read the below-mentioned instructions carefully before starting the diffuser.
1
Back
60 120 Non stop
LIGHT
ON/OFF
2
C
LIGHT
ON/OFF
Back
LIGHT
ON/OFF
6
CMP-138_NOTICE_DBP_UrbanChic-1399_06-14.indd 6
STAGE 1
The perfume mist diffuser - URBAN CHIC EDITION is boasted of a wireless system and
around a 3 hours of autonomy, to diffuse the fragrance of your choice in total freedom.
Thanks to its compact design, it becomes a nomad perfume mist diffuser that you can take
with you wherever you go and create the fragrant atmosphere you prefer in your home,
office, hotel room, etc.
Carefully follow these instructions for charging your diffuser's battery.
• Before using your perfume mist diffuser - URBAN CHIC EDITION for the first time, fully
charge the battery. To do so:
- insert the electricity cable into the port on the diffuser's underside before connecting it
to the mains or to a USB port: the blue light should blink on and off throughout charging.
- check that the electric plug is in conformity with your country's electricity installation. If
not, add a universal adapter to the plug (see non-exhaustive list of countries on page 24).
- in order to avoid any accident, make sure that the cable is not located in an area
where people walk.
- use only the elements provided with your diffuser to charge the battery.
• Once the battery is fully charged, the blue light under the
use your diffuser however you like, either wireless or plugged in, in any room of your home.
• If you want to switch to wireless (battery-operated) mode when the device is diffusing
and connected to the mains, ensure the battery has sufficient charge to allow the device
to continue diffusing.
• It takes 5-6 hours to fully charge the battery from the mains and 5-9 hours using the
USB port (depending on the USB port). Battery life and charging cycles will vary according
to use and settings.
• Ensure you charge the battery whenever it is running low, e.g. when the blue light blinks
on and off under the
STAGE 2
• Place the diffuser on a flat and stable surface away from the edge.
• Remove upper part A, unscrewing it counter clockwise, while keeping the diffuser base
A
straight.
• Pour water at room temperature into the container by using the graduated glass C
keeping to the indicated graduation level. Do not exceed the maximum level of
100ml (Warning: the diffuser does not work if the water level is too low or higher than
100ml).
• Do not pour hot water into the container (risk of damage of sensitive components).
100 ml
• Add a few drops of ESTÉBAN refresher oils or essential oils: at least 10 or more,
max
depending on the expected intensity (the harshest and most viscous essential oils should
not be used as they may damage your diffuser).
B
Do not pour drops of refresher oils or essential oils into the
-
container if there is no water in it as this risks damaging the device.
- Wipe up any drops that may accidentally have fallen outside the container.
- An excess of refresher oils or essential oils could prevent the diffusion and damage
the diffuser.
• Place the upper part A back on the base B, ensuring the two grey dots at the right of
the buttons are properly aligned.
symbol.
GB
symbol will go out. You can then
17/06/2014 11:13