ESTEBAN URBAN CHIC EDITION Instrucciones De Uso página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
OPERATION AND MAINTENANCE INSTRUCTIONS
CLEANING
After each use, to avoid spotting and bad smells clean the appliance
by following these steps:
• switch it off and/or unplug from the mains/the USB port
TAKE CARE NOT TO TILT THE DIFFUSER IF
THERE IS ANY WATER IN THE CONTAINER
• remove the upper part A
• empty out the container by following the direction of the
arrow "DRAIN SIDE" to avoid any contact with electrical parts
as well as the air vent labelled "AIR OUTLET"
• clean the water container in order to remove all residues, for it use
absorbent paper impregnated with a mild detergent (soap, washing-
up liquid... Do not use aerosol sprays, solvents or abrasive products
that might damage the appliance). Then wipe it with a dry cloth
• use a soft cloth with a little of water if necessary to clean the
outside of the appliance
• use a wet cotton bud (water only) to clean the ceramic disk
• as this disk is very fragile and sensitive, make sure not to press too
strong and clean it after each use for longer operating life.
REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms
The diffuser does not start up
or switches off during diffusion
The battery light is blinking
on and off
No mist when the appliance is
switched on
Mist stops while the diffuser is
in operation
Insufficient mist
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
8
CMP-138_NOTICE_DBP_UrbanChic-1399_06-14.indd 8
Causes
The battery has run out or does not have enough charge
Low battery
Water level too low
Water level exceeds 100 ml
The end of part A is obstructed
Water level too low
Accumulation of water drops at the mist vent of part A
The ceramic disk is dirty
An excess of Estéban refresher oils or essential oils has
been poured into the container
Accumulation of water drops at the mist vent of part A
Incorrect alignment of 2 grey dots between parts A and B
NEW USE
if you charge your diffuser when there is water left in
the container, take care not to tilt the diffuser when
connecting the energy supply cable
• see STAGE 1 and STAGE 2 of the section "STARTING THE
DIFFUSER"
• replace the water in the container frequently to avoid any residue
that might damage the appliance
• empty out the liquid remaining after each use and clean the water
container and its ceramic disk each time you change the water or
fragrance, for an optimum fragrance.
LONG PERIOD WITHOUT USE
If the appliance is not going to be used during a long period, clean it, dry
it (by following the instructions in section "CLEANING"), and keep it
in a dry place.
Connect the electric cable to the underside of the device
ensuring you do not tilt it if there is any water left
in the container, and connect it to the mains. Wait until the
device battery is completely recharged (blue light off)
Fill the water container
Empty out excess water
Make sure that nothing is preventing the release of the mist
Fill the water container
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Clean the ceramic disk as described in the "CLEANING"
instructions
Empty the appliance by following the direction of the
arrow "DRAIN SIDE" and clean it
Switch off the appliance, remove part A then clean off the
accumulated water drops
Adjust the cap of part A onto the base of diffuser B by
lining up the 2 grey dots
Solutions
17/06/2014 11:13

Publicidad

Tabla de contenido
loading

Tabla de contenido