Bosch CET8-15W Instrucciones De Funcionamiento página 5

Power cord plugs must match the outlet. Nev-
er modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools.
Unmodified plugs and matching outlets
will reduce risk of electric shock.
Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of elec-
tric shock if your body is earthed or grounded.
Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
keep cord away from heat, oil, sharp edges or
moving parts. Replace damaged cord immedi-
ately. Damaged or entangled cords increase the
risk of electric shock.
Do not expose this compressor to rain. Do not
use in damp or wet locations. Moisture increas-
es the risk of electric shock with this equipment.
Do not touch plug with wet hands. Moisture in-
creases the risk of electric shock with this equip-
ment.
keep all electrical connections dry and off the
ground. Do not allow electrical connections to
lay in water or in such a position where water
could come into contact with cord and con-
nection. Moisture increases the risk of electric
shock with this equipment.
SAFETy RULES FOR ELECTRIC COMPRESSORS
SAVE THESE INSTRUCTIONS
When operating a power tool outdoors, use an
extension cord suitable for outdoor use and
with correct amperage capacity. Use of a cord
rated for outdoor use reduces the risk of electric
shock.
Always disconnect compressor from power
supply, vent air tanks, and allow compressor
to cool before servicing. Compressors with au-
tomatic pressure controls can restart at any time.
Always turn off the motor when not in use and
before moving compressor. Stopping the motor
prevents unintentional starting of the compressor.
Some dust created by power sanding, sawing,
grinding, drilling, and other construction activ-
ities contains chemicals known to cause can-
cer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic par-
ticles.
5