Extension Cords - Bosch CET8-15W Instrucciones De Funcionamiento

lUBrICATION AND OIl
Do not attempt to operate this air
CAUTION
compressor without first verifying
the oil level in the crankcase. This compressor
is shipped with oil in the crankcase. Serious
damage of the compressor can result from even
momentary operation without proper lubrication.
Prior to each use, verify the crankcase oil level.
An oil sight gauge with minimum and maximum
oil level marks is provided with this compressor.
Always verify that the oil level is at the maximum
mark in the oil sight gauge before operating this
unit. Do not operate the pump with an inad-
equate or excessive amount of oil. The cost of
failures which occur due to incorrect oil levels will
not be covered under warranty.
To check the oil level:
1. Place unit on a level surface.
2. Verify oil level through the oil sight gauge.
3. If oil level is low, add as required, but do not
exceed maximum oil level.
Do not allow particulates such
CAUTION
as sawdust to fall into crank
case when crank case is open for inspection.
Particulates in oil may reduce compressor life.
Do not use a detergent oil in
CAUTION
crankcase. Detergent oils will leave
deposits on internal compressor components
reducing compressor life and performance.
ASSEMBLy / INSTALLATION
Fig. 1
GrOUNDING
This product must be grounded. In the event of
an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire
for the electric current. This product is equipped
with a cord having a grounding wire with an ap-
propriate grounding plug. The plug must be in-
serted into an outlet that is properly installed and
grounded in accordance with all local codes and
ordinances.
GROUNDED
OUTLET
GROUNDING
PIN
Fig. 2
Improper
WARNING
grounding plug is able to result
in a risk of electric shock. When repair or
replacement of the cord or plug is required, do
not connect the grounding wire to either flat blade
terminal. The wire with insulation having an outer
surface that is green with or without yellow stripes
is the grounding wire.
Check with a qualified electrician or service-
man when the grounding instructions are not
completely understood, or when in doubt as to
whether the product is properly grounded. Do not
modify the plug provided; if it does not fit the out-
let, have the proper outlet installed by a qualified
electrician.
This product is for use on a nominal 20-V circuit
and has a grounding plug similar to the plug illus-
trated below. Only connect the product to an out-
let having the same configuration as the plug. Do
not use an adapter with this product.

exTeNSION COrDS

Use only a 3-wire extension cord that has a 3-
blade grounding plug, and a 3-slot receptacle that
accepts the plug on the product. Make sure your
extension cord is not damaged. When using an
extension cord, be sure to use one heavy enough
to carry the current your product draws
installation of the
7