Extel WEVP 461 E BIS Instrucciones De Uso página 41

b. Roadside panel
1. Flush mount the plastic box (3) taking care not to block the locking nuts of the roadside panel
(you can install your roadside panel without flush-mounting it, with the WEBS 42 BIS optional
surface-mounted box)
2. Remove the 2 screw covers (4) with a small screwdriver to put in the notches (5)
3. Connect the wires of the monitor observing the wiring diagram, for connecting a strike/lock or
an automatic gate opener, there is no polarity to observe.
4. Fix the roadside panel on the flush-mounted box with 2 special screws supplied with their
assembly key (2).
5. Install the 2 screw covers (4)
The camera being flush mounted, we advice you to protect it from the rain with the optional
WEBC 42 BIS rain shield or with an inclined tile or any other mean and do not expose it to
direct sun light or to reflective surface.
Put a silicon gasket on the upper half
part between the roadside panel and
the wall.
Do not put silicon gasket on the lower
half part in order to avoid any vapour
and premature oxidation of electronic
parts.
8EN
1,60 m