BABYTREND muv HC57D Manual De Instrucciones página 10

CAR SEAT
INFANT CAR SEAT
WARNING:
Avoid
serious injury from falling or
sliding out, always use the
Infant Car Seat harness.
ADJUST FRAME HEIGHT
WARNING:
Do not adjust
car seat height with child in seat.
Adjust seat height before placing
your child in the car seat.
WARNING:
Always
check that the Height Adjustment
Bracket is level and both left and
right sides locked before placing
child in the car seat.
WARNING:
Never use
the car seat mode at any of the
higher positions. Always use the
car seat at the lowest position.
WARNING:
Never rest
the height adjustment bracket
on the locking pins.
• Squeeze both left and right Release
23)
Handles of the Height Adjustment Bracket
and adjust to the lowest position (Fig. 23a).
DO NOT adjust with child in the seat.
19
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Release Handle
Fig. 23a
Highest Position
Lowest Position
Locking Pin
Fig. 23b
ATTENTION:
The Height Adjustment Bracket must be set at
the lowest postion before placing car seat (Fig.
23b).
TO ATTACH CAR SEAT
• Connect the Car Seat and lock into place
24)
(Fig. 24a). Make sure its locked firmly in
place before use (Fig. 24b).
TO REMOVE CAR SEAT
• Detach Car Seat from Upper Frame
25)
Assembly by pushing both modular
release buttons on each side of the seat
and lifting seat upwards (Fig. 25).
DO NOT remove with child in the seat.
CAR SEAT MODE
Face in either direction,
front or backwards.
Infant car seat sold separately
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos Los Derechos Reservados.
CAR SEAT
Fig. 24a
Fig. 24b
Fig. 25
20