Maintenance - Optika B-600 MET Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.0 MAINTENANCE

5.1
Always think about
-
The following environment is required: Indoor temperature: 0-40°C, Maximum relative humi
dity: 85 % (non condensing).
-
Keep the microscope away from dust and shocks while in use.
-
Turn off the light immediately after use.
-
Use a soft lens tissue to clean the optics after use.
-
Only if needed, use a cloth moistened with water and a mild detergent, rinsing with
water and drying immediately with a lint-free cloth.
-
After use, cover the microscope with the included dust-cover, and keep it in a dry and clean
place.
5.2
Do not!
-
Wipe the surface of any optical items with your hands. Fingerprints can damage the optics.
-
Use solvents, neither on the microscope, nor on the optics.
-
Disassemble objective or eyepieces to attempt to clean them.
-
Mishandle or impose unnecessary force on the microscope.
-
Clean the unit with volatile solvents or abrasive cleaners.
-
Attempt to service the microscope yourself.
5.3
How to change the brightfield lamp
-
Before changing the lamp, you must pull the plug out of the electrical socket. To avoid being
burnt, wait until the lamp has cooled down.
-
Remove the lamp housing by pulling it out of the back of the microscope.
-
Pull out the old lamp.
-
Hold the new lamp without touching it with your bare hands (e.g. using its packaging, or a
cloth) and insert it into the holder. Replace/close the lamp holder.
Page 10

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido