Machine Components; Paper Jam - HSM shredstar S5 Instrucciones De Servicio

Check the machine and cable regu-
larly for damage. Switch the shred-
der off if it is damaged or not work-
ing correctly or before relocating or
cleaning it and disconnect it from
the mains.
– Keep the machine, the plug and cable away
from open fi re and hot surfaces. The ventila-
tion slots must not be blocked or covered
and there must be at least 5 cm space be-
tween the shredder and any wall or furniture.
Service work may only be carried
out by HSM Customer Service or by
the service technicians of our con-
tractual partners.
See page 72 for our customer ser-
vice addresses.
Notice Danger from improper use
Only operate this machine in accordance with
the instructions outlined in "Proper use".

3 Machine components

1 3 2 4
1 Cut material container
2 Feed opening
3 Slider switch
4 Cutting head
8
4 Operation
Warning!
Before switching the machine on,
make sure that you observe all safety
instructions.
• Set the sliding switch for automatic
operation to "ON/AUTO".
ON/AUTO OFF REV
• Feed in the paper to be shred-
Swit ching paper shredder off
• Set the sliding switch to "OFF".
ON/AUTO OFF REV
5 Troubleshooting

Paper jam

• Set the slider switch to "REV".
Pa per is pus hed out.
• Set the slider switch to "ON/AUTO"
ON/AUTO OFF REV
again.
• Do not feed in too many sheets at
once.
Shredded material container
Check the level in the shredded material con-
tainer and empty it in good time, as otherwise
the function of the cutting device could be im-
paired.
For all other malfunctions, check whether the
cutting head was correctly positioned on the
shredded material container before contacting
our customer service. If the motor was over-
loaded, let the shredder cool down for 15 to
20 minutes before using it again.
shredstar S5
english
ded, however, never feed in
more than 5 sheets at a time.
 The cutting device starts auto-
matically, pulls in the paper and
shreds it.
 When the feed opening is
clear of paper again, the cutting
device switches off.
01/2013