Machine Components - HSM Shredstar X10 Instrucciones De Servicio

Check the machine and cable regu-
larly for damage. Switch the shred-
der off if it is damaged or not work-
ing correctly or before relocating or
cleaning it and disconnect it from
the mains.
– Keep the machine, the plug and cable away
from open fi re and hot surfaces. The ventila-
tion slots must not be blocked or covered
and there must be at least 5 cm space be-
tween the shredder and any wall or furniture.
Service work may only be carried
out by HSM Customer Service or by
the service technicians of our con-
tractual partners.
See page 72 for our customer ser-
vice addresses.
Notice Danger from improper use
Only operate this machine in accordance with
the instructions outlined in "Proper use".
8

3 Machine components

1 2 3 4 5 6 7
1 Shredded paper container
2 LED indicator
3 Sliding switch for operating mode
4 Safety notice
5 Feed opening for paper
6 Feed opening for CDs and cards
7 Cutting head
4 Setting up
WARNING
Danger of injury from sharp blades
on the underside of the device.
• Carefully place the cutting head
• Connect the power plug of the
Note: The document shredder can only be
switched on if it has been placed correctly on
the shredded material container belonging to it.
shredstar X10
english
on the container for shredded
material.
machine into a properly installed
socket.
06/2014