Safety Instructions; Assembly Instruction; Basic Instruction For Operation; Program Mode - Hyperion IRT 3-1 PcD Manuale Di Uso E Manutenzione

Children should be supervised to ensure that they do not
play with the appliance.
Dispose of used items at the nearest environmental
protection facility for recycling.
For safety reasons the infrared dryer must be supplied by
recommended maximum fuse, see tables in chapter 2.2.
4.

Safety instructions

The mobile dryer must not be exposed to paint fog, sand-
ing dust or solvents, due to fi re risk. Furthermore, this
will reduce the lifetime of the dryer. Allow for suffi cient
cooling time of the dryer. The distance to the object to be
dried must be suffi cient. Otherwise there is risk for fi re
or explosion! Keep all fl ammable materials in a suffi cient
distance from the hot surfaces of the dryer.
4.1 Hazards
Tilting
The risk for tilting increases when the arm is located in
an upright position. Turning both cassettes to one side
also increases the risk for tilting.
Fire and explosion.
Do not store, prepare or use solvent-containing materials
within a 5 m/16 feet radius of the mobile dryer. Flam-
mable materials should not be placed close to a drying
device in use.
If you have a distance less than 60 cm/2 feet to the
object the temperature might raise quickly and the risk
for fi re increases. Never direct the cassette towards highly
combustible materials.
Electrical equipment
The mobile dryer is operated with high electrical voltage,
which can be highly dangerous.
Before accessing live parts, remove the main
connector from the wall socket. Only professional electri-
cians may have direct access to the electrical compo-
nents.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualifi ed
persons in order to avoid a hazard.
WARNING !
Intensive heat radiation. Hands, face and other parts of
the body should be exposed as little as possible to the
heat radiation.
5.

Assembly instruction

See separate document for detailed instructions:
For the mobile dryers:
713847 Assembly Manual IRT Pc Mobile
For the rail systems:
713683 Assembel Manual IRT 4-20 PcAuto
IRT 3-20 PcD
4
IRT 3-1 PcD, IRT 3-2 PcD and IRT 3-20 PcD
6.

Basic instruction for operation

6.1 Keyboard
Software defi ned button
Confi rmation choices
Start
Stop
Cassettes in use
)
(one or two
6.2 Display
Active program
Flash off – active
Full bake – inactive
Confi rmation choices
6.3

Program mode

This mode is for your everyday use. It helps you run the
dryer with pre-installed programs and edit program settings.
When you start the dryer, an information screen will appear
for two seconds. By pressing the confi rmation or cancella-
tion button this information will show until released. The
diagram shows cassette fi lter usage and notifi es when it's
time to change fi lter. To replace fi lter see chapter "9.1 Filter
replacement".
6.4 Settings mode
The Settings mode enables you to change advanced system
parameters. Thanks to our advanced control system in this
mobile dryer there are many settings that can be altered.
This is normally not a part of the everyday usage.
To enter the settings mode press both arrow keys when you
turn the main switch to position 1.
Read chapter 8 for more information.
Software defi ned button
Cancellation choices
Enter
(Temperature control)
Not available for this
model
One cassette active
Cancellation choices
To enter the program mode, turn
the main switch on.
713686 rev 7