Installation Of The Fan - THERMEx THR 100 Manual De Instrucciones

58
THERMEX THR 100

INSTALLATION OF THE FAN

NOTE: THR 100
The must be installed horisontally and therefore NEVER mounted on a ceiling.
The following steps must be followed when installing THR 100.
1
110 mm
Measure out on the wall for where the fan is to
be placed.
NOTE: THR 100
The must be mounted AT LEAST
2.3 metres above floor level.
4
Measure out and pre-drill the four holes for the
exhaust hood.
7
x4
Mount the cover caps onto the screws in the
exhaust hood.
2
110 mm
2-5 %
Drill a hole of 110 mm in the wall.
NOTE: There should be a downward angle of
between 2 and 5 degrees from the inside and
out.
5
x4
Install rawl plugs suitable for the material into
which they are installed.
8
Push the pipe and the heat recovery core into
the hole in the wall.
NOTE: Make sure that the cut section of pipe
faces down to avoid the wire from the fan be-
coming trapped.
M 760081000218072017
3
Remove the four cover caps from the screw ho-
les in the exhaust hood.
6
Mount the exhaust hood on the wall.
9
Remove the front panel from the fan.
x4