Surface Mounting - Raymarine Lighthouse eS Serie Manual Del Usario

5.1 Surface mounting

The display can be surface mounted.
Before mounting the unit, ensure that you have:
• Selected a suitable location.
• Identified the cable connections and route that the
cables will take.
• Detached the Menu/Home buttons keypad.
• Detached the front screw covers.
1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel
is required.
2. Fix the appropriate cutting template, supplied
with the product to the selected location, using
masking or self-adhesive tape.
3. Using a suitable hole saw (the size is indicated
on the template), make a hole in each corner of
the cut-out area.
4. Using a suitable saw, cut along the inside edge
of the cut-out line.
5. Ensure that the unit fits into the removed area
and then file around the rough edge until smooth.
6. Drill 4 holes as indicated on the template to
accept the fixings.
7. Place the gasket onto the rear of the display and
press firmly onto the flange.
8. Connect the power, data and other cables to the
unit.
9. Slide the unit into place and secure using the
fixings provided.
10. Attach the Menu/Home buttons keypad, by sliding
it down from above the display.
56
11. Attach the screw covers, by sliding in from either
side of the display.
Note: The supplied gasket provides a seal
between the unit and a suitably flat and stiff
mounting surface or binnacle. The gasket should
be used in all installations. It may also be
necessary to use a marine-grade sealant if the
mounting surface or binnacle is not entirely flat and
stiff or has a rough surface finish.
Fitting the Menu-Home button
D13277-2
Follow the steps below to fit the Menu/Home button
to the display.
1. Squeeze the top of the button assembly between
your fingers and thumb.
Squeezing the top will lever the bottom of the
backing plate farther away from the buttons,
creating a bigger gap to enable the assembly to
be fitted.
D13278-2
D13336-1
eS Series installation instructions