Resetting The Recorder; Maintaining; Care And Handling Of Discs; Specifications - Insignia NS-1DRVCR Guia Del Usuario

Maintaining

Care and handling of discs

Handling discs
Do not touch the playback side of the disc. Hold
the disc by the edges so that fingerprints do not
get on the surface. Never stick paper or tape on
the disc.
Storing discs
After playing, store the disc in its case. Do not
expose the disc to direct sunlight or sources of
heat and never leave it in a parked car exposed
to direct sunlight.
30
Cleaning discs
Fingerprints and dust on the disc can cause
poor picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe
the disc from the center out.
Do not use strong solvents such as alcohol,
benzine, thinner, commercially available
cleaners, or anti-static spray intended for older
vinyl records.

Resetting the recorder

Reset your recorder if you observe any of the
following symptoms:
• When the recorder is plugged in, but the
power will not turn on or off.
• When the display window does not working.
• When the recorder does not operate
normally.
To reset the recorder:
• Press and hold the POWER button for more
than five seconds. This forces the recorder to
turn off. Press the POWER button again to
turn the recorder back on.
- OR -
Unplug the power cord and then plug the
power cord again after more than five
seconds.

Specifications

General
Power requirements
Power consumption
Dimensions (approx.)
(w × h × d)
Mass (approx.)
Operating temperature
Operating humidity
Signal system
www.insignia-products.com
Never operate this product immediately after
moving it from a cold location to a warm
location. Leave it for two or three hours
without operating it. If you use this product in
such a situation, it may damage tapes, discs,
or internal parts.
AC 120V, 60 Hz
24W
16.9 × 3.1 × 10.2 in.
(430 × 78.5 ×
266 mm)
10.14 lbs (4.6 kg)
41°F to 95°F
(5°C to 35°C)
5% to 90%
NTSC