Maintaining; Care And Handling Of Discs; Resetting Your Recorder - Insignia NS-1DVDR Guía Del Usario

The remote There is an obstacle
control does in the path of the
not work remote control and
correctly your recorder.
The batteries in the
remote control are
exhausted.
The remote control is
not pointed at the
remote sensor of
your recorder.
The remote control is
too far from your
recorder.
Timer The recorder clock is
recording is not set to the correct
not possible time.
The timer has been
programmed
incorrectly.
The TIMER Record
indicator light does
not appear after
programming the
timer.
Cannot play The disc was
disc a recorded in Video
recorded on mode.
your
Some players will not
recorder on
play even a finalized
another
disc recorded in
DVD player
Video mode.
The disc was
recorded in VR mode.
Discs recorded with
copy-once material
cannot be played on
other players.
Cannot Not enough blank
record or space remaining on
did not the disc.
record
successfully
The source you are
trying to record is
copy-protected.
When recording to a
Video mode disc,
programs that are
copy-once protected
cannot be recorded.
24
Remove the obstacle.
Replace the batteries with
new ones.
Point the remote control at
the remote sensor of your
recorder.
Operate the remote control
within 23 ft (7 m).
Set the clock to the correct
time.
Reprogram the timer.
Reprogram the Timer and
turn off your recorder to
enable the timer.
Finalize the disc. See "Disc
Settings" on page 12.
No solution.
The other player must be RW
compatible in order to play
the disc.
No solution.
Use another disc.
You cannot record the
source.
Use a VR mode formatted
disc for copy-once material.
www.insignia-products.com

Maintaining

Care and handling of discs

Handling discs
Do not touch the playback side of the disc. Hold
the disc by the edges so that fingerprints do not
get on the surface. Never stick paper or tape on
the disc.
Storing discs
After playing, store the disc in its case. Do not
expose the disc to direct sunlight or sources of
heat and never leave it in a parked car exposed
to direct sunlight.
Cleaning discs
Fingerprints and dust on the disc can cause
poor picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe
the disc from the center out.
Do not use strong solvents such as alcohol,
benzine, thinner, commercially available
cleaners, or anti-static spray intended for older
vinyl records.
Note
Never operate this product immediately after
moving it from a cold location to a warm
location. Leave it for two or three hours
without operating it. If you use this product in
such a situation, it may damage discs or
internal parts.

Resetting your recorder

Reset your recorder if you observe any of the
following symptoms:
• When your recorder is plugged in, but the
power will not turn on or off.
• When the display window does not working.
• When your recorder does not operate
normally.
To reset your recorder:
• Press and hold the POWER button for more
than five seconds. This forces your recorder
to turn off. Press the POWER button again to
turn your recorder back on.
Or, unplug the power cord and then plug the
power cord again after more than five
seconds.