Little Giant M13 Instrucciones De Funcionamiento página 14

I. TIP & GLIDE™ Wheel Instructions
Note: Depending on your ladder model, the TIP & GLIDE wheels may or may not be
included or available.
1. With the ladder in its storage position, hold the ladder by the top outer rung and tip the
EN
ladder until the wheels make contact and the feet lift up off the ground (Fig. 47).The
ladder can now be freely wheeled across flat hard surfaces by pulling it behind you.
WARNING:
MODE, POINTED AWAY FROM THE STAIRS IN THE STAIRCASE MODE, AND FACING
OUTWARD IN THE SCAFFOLDING TRESTLE MODE. FAILURE TO DO SO MAY CAUSE
THE WHEELS TO CONTACT THE GROUND UNEXPECTEDLY AND CAUSE INJURY.
J. AIRDECK
Note: Accessory ports are required to utilize the AIRDECK workstation. Depending on
your ladder model, the ports and the workstation may or may not be included or
compatible.
1. The accessory ports are located on the hinges of the ladder. Depending on your ladder
model, they can be either fixed-position or 2-position ports. The fixed-position ports allow
you to use the AIRDECK workstation in the vertical safety handrail position, either with or
without using the tool tray. The 2-position ports also allow you to use the workstation as
a lower horizontal tool tray, without using it as a safety handrail.
a) 2-position accessory port instructions
1) Slide the insert upward (Fig. 49). This will unlock the port and allow it to be
repositioned.
2) Rotate up and back until it swings all the way around and clips in place (Fig. 50).
3) To return the port to the original position, reverse these steps, starting by pulling up
until the port unclips, and making sure the port is latched in the locked position when
finished.
WARNING:
BEFORE INSERTING THE WORKSTATION. NEVER ADJUST THE PORTS WHEN
THE WORKSTATION IS IN USE.
14
WHEELS SHOULD ALWAYS BE TO THE TOP IN THE STRAIGHT LADDER
Workstation Instructions
®
48
PORTS MUST BE SET AND LOCKED IN THEIR DESIRED POSITIONS
46
49
47
50