Descargar Imprimir esta página

Little Giant M13 Instrucciones De Funcionamiento página 8

Ocultar thumbs Ver también para M13:

Publicidad

Idiomas disponibles

Idiomas disponibles

B. The Outer Ladder Locks - Located at the tops of the outer ladder assemblies. There are
four of these on each ladder. They permit you change the height of the ladder (Fig. 16-17).
EN
Since the outer ladder assemblies can be adjusted independently, setting them at different
lengths is how you achieve the 90-degree and staircase modes. You can also completely remove
the outer assemblies from the inner and link them together to create a scaffolding trestle.
WARNING:
WITHOUT AT LEAST ONE FLARED OUTER BASE ATTACHED. NEVER USE INNER OR
OUTER SECTIONS AS A SEPARATE STEPLADDER.
1. Unlocking Outer Ladder Locks - Depending on your particular ladder model, it will have
one of the following outer ladder lock styles:
a) ROCK LOCK
fasteners
b) RAPID LOCK
or EZ LOCK™
fasteners
c) Lock tabs
WARNING:
THE LADDER. ALWAYS MAKE SURE ALL OUTER LADDER LOCKS ARE FULLY LOCKED
BEFORE CLIMBING. FAILURE TO DO SO MAY RESULT IN INJURY OR DEATH.
8
NEVER USE INNER LADDER AS A STEPLADDER OR STRAIGHT LADDER
®
To unlock, press in on the bottom of the ROCK LOCK fastener until it
clicks into the open (unlocked) position (Fig. 20).
®
To unlock, twist and pull the RAPID LOCK or EZ LOCK fastener 90
degrees until it rests in the open (unlocked) position (Fig. 23).
To unlock, pull the lock tab outward until it is completely removed from
the rung hole, then rotate it away from the hole and release it. It will rest
in the open (unlocked) position (Fig. 26).
NEVER RELEASE ANY OF THE OUTER LADDER LOCKS IF ANYONE IS ON
16
18
21
24
17
19
22
25
20
23
26

Publicidad

loading

Este manual también es adecuado para:

M17M22M26