Tabla de contenido
Publicidad
when the installation has been
completed.
Be careful not to damage the
floors (e.g. parquet) when moving the
appliance. Install the appliance on
a floor or support strong enough to
take its weight and in a place suitable
for its size and use. Make sure the
appliance is not near a heat source
and that the four feet are stable and
resting on the floor, adjusting them
as required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance on, to
ensure that the refrigerant circuit is
fully efficient.
All dimensions and spacing needed
for installation of the appliance are in
the Installation Instruction booklet.
WARNING: When positioning the
appliance, ensure the supply cord is
not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning or fixing
of the appliance must be done in
accordance with the manufacturer
instructions.
It's forbidden to place the refrigerator
in such way that the metal hose of
gas stove, metal gas or water pipes,
or electrical wires are in contact with
the refrigerator back wall (condenser
coil).
ELECTRICAL WARNINGS
It must be possible to disconnect
the appliance from the power
supply by unplugging it if plug is
accessible, or by a multi-pole switch
installed upstream of the socket in
accordance with the wiring rules
and the appliance must be earthed
in conformity with national electrical
safety standards.
Do not use extension leads,
multiple sockets or adapters. The
electrical components must not
be accessible to the user after
installation. Do not use the appliance
when you are wet or barefoot.
Do not operate this appliance if it has
a damaged power cable or plug, if
it is not working properly, or if it has
been damaged or dropped.
If the supply cord is damaged, it
must be replaced with an identical
one by the manufacturer, its service
agent or similarly qualified persons
in order to avoid a hazard - risk of
electric shock.
WARNING: Do not locate multiple
portable socket-outlets or portable
power supplies at the rear of the
appliance.
CLEANING AND MAINTENANCE
WARNING: Ensure that the
appliance is switched off and
disconnected from the power supply
before performing any maintenance
operation; never use steam cleaning
equipment - risk of electric shock.
Do not use abrasive or harsh
cleaners such as window sprays,
scouring cleansers, flammable
fluids, cleaning waxes, concentrated
detergents, bleaches or cleansers
containing petroleum products
on plastic parts, interior and door
liners or gaskets. Do not use paper
towels, scouring pads, or other harsh
cleaning tools.
6
Publicidad
Tabla de contenido
