End User; Putting Into Service; Temporary Or Short-Term Shut-Down - Riello BOLLITORE 120 Lt Para El Usuario

2 END USER

2.1

Putting into service

The first start up of the BOLLITORE 120 Lt
be carried out by the Technical Assistance Service
which the appliance will be able to operate automatically.
However, the user may need to automatically restart the BOL-
LITORE 120 Lt without involving the Technical Assistance Service;
for example after a long period of absence.
Before doing so, perform the following checks and operations:
− make sure that the fuel and water taps of the heating
system (not supplied) are open.
− make sure that the boiler connected to the storage cylin-
der is in service referring to the section "Commissioning
and maintenance" of the boiler's instructions
− start the domestic hot water function on the boiler (see
the specific chapter in the boiler's instruction booklet).
9
The storage cylinder depends on the heat generator to
which it is connected in order to operate.
2.2
In the event of temporary or short-term shut-down (e.g. due to
holidays), proceed as follows:
R appliance should
R after
9
Then proceed as follows:
45

Temporary or short-term shut-down

− deactivate the domestic hot water function on the boi-
ler combined with the storage cylinder (see the specific
chapter in the boiler's instruction booklet);
If the outdoor temperature drops below ZERO, (risk of frost),
the procedure described above SHOULD NOT be carried out.
− lower the domestic hot water setpoint on the display of
the boiler to the minimum allowed;
°C