How to use
1. If the clipper is fully charged, you don't need to worry about the trouble of boring wires any
more. It is more flexible to groom your pet in this way.
2. If the battery runs out, you can power it via the adapter with a 2.5 m cable to groom your pet in
a limited area.
How to Remove and Install Blades and Combs
When you remove and install a blade or comb, please make sure that the switch button is turned
off so as to prevent injury.
Removing and installing the blade
1. Removing: hold the clipper in both hands with the front of the device facing you, then press both
thumbs on the blade teeth and push outwards.
2. Installing: slide the blade on the clipper straight down. Line up the plastic clasps and click the
blade into place. Please make sure that the teeth point away from you.
Installing and removing the comb
1. Hold the clipper in left hand and the two sides of the comb in right hand, then click them into
place.
2. Hold the clipper in both hands and push the two sides outwards with your thumbs.
How to Groom Your Pet
1. Legs and paws: comb leg hair and cut long parts first. Gently but firmly pick up the pet's legs
and hold it straight out in front. Don't bend legs into an awkward position. Take extra care when
clipping the hair on the paws.
2. Head: pick up the pet's mouth and keep the pet steady. Install with a comb and clip the head on
the same side of the hair growth. Clip the muzzle by beginning at the bridge of the nose. After
done, please use scissors for better trimming.
Attentions
1. The 2.5 m cable is flexible enough to groom your pet when the pet clipper is charging. Please
never drag the cable so as to avoid electricity leakage, short circuit and fire.
2. This pet clipper is not waterproof, so please never groom your pet while bathing.
3. Please never cut thick tangled hair. Doing so will wear the blade and shorten the lifetime of the
clipper.
4. Do not use the battery charger for other electrical appliances, which may lead to accidents.
Battery Clipper Set TR1150
#23882
11