Stryker Stair-PRO 6250 Manual De Uso página 40

English
TRACK BELT REPLACEMENT (FOR MODEL 6252) - CONTINUED
7. Thread the new belts through the wheel support plate.
8. Replace the track rollers, washers, hex head cap screws
and nuts.
9. Use two 7/16" wrenches to apply the desired tension to
each belt and tighten securely.
Note: To check the tension, pull up on the center of the belt
until it is taut. The gap between the belt and the track frame
should measure between 3/8" and 1" as shown in Figure 54.
10. Spin the belts to verify they roll freely.
Return To Table of Contents
1-38
Service Information
Figure 53 - Use wrenches to apply tension to the
6250-001-161 REV D
Figure 52 - Attach the new track belt
belts
Figure 54 - Proper belt tension
www.stryker.com